Unify @ref and @command usage

[nncp.git] / doc / mcd.texi

diff --git a/doc/mcd.texi b/doc/mcd.texi
index 282261e978fdd324ad364a5179402aaea50490d2..a161f0389fb6e80bb8c0f2724aca6e5c8c377ca4 100644 (file)
--- a/doc/mcd.texi
+++ b/doc/mcd.texi
@@ -9,10 +9,11 @@ in local area network. It is very simple:
 
 @itemize
 @item
-    @ref{nncp-daemon} sends multicast messages about its presence from
-    time to time. See @ref{CfgMCDSend, mcd-send} configuration option.
+    @command{@ref{nncp-daemon}} sends multicast messages about its
+    presence from time to time. See @ref{CfgMCDSend, mcd-send}
+    configuration option.
 @item
-    When @ref{nncp-caller} sees them, it adds them as the most
+    When @command{@ref{nncp-caller}} sees them, it adds them as the most
     preferred addresses to already known ones. If MCD address
     announcement was not refreshed after two minutes -- it is removed.
     See @ref{CfgMCDListen, mcd-listen} and
@@ -32,5 +33,5 @@ identifier of the node. It is sent as UDP packet on IPv6
 @strong{@verb{|ff02::4e4e:4350|}} (hexadecimal ASCII @verb{|NNCP|})
 multicast address and @strong{5400} port. Operating system will use IPv6
 link-local address as a source one, with the port taken from
-@command{nncp-daemon}'s @option{-bind} option. That way, IP packet
+@command{@ref{nncp-daemon}}'s @option{-bind} option. That way, IP packet
 itself will carry the link-scope reachable address of the daemon.